There’s been a lot written about the Raspberry Pi, a small single-board computer with I/O pins on the circuit board, and a small price tag (£25 or so). For me, the most exciting aspect of the Raspberry Pi is the fact that it has lots of methods of input and output of digital signals to and from the board.
Lots of people have reported good things about the toner transfer method of making printed circuit boards. Lots of other people have said it’s a waste of time. I have been trying to use this technique to produce decent quality boards, with quite a few successes so far.
Here’s a little tip for anyone with an Oil Watchman tank guage. If your batteries run out, you don’t need to spend £30 or so replacing it. You can open the tube and replace the four AAA cells that are inside, it’s a simple five minute job.
Some notes on the SmartAlpha module from RF Solutions, though these may have been superseded by a revised firmware that appears to have made it onto the device.